Fandom

Gun Wiki

List of wheellock accessories and parts

1,855pages on
this wiki
Add New Page
Comments0 Share
Wheellockstatic

An animated diagram showing each of the wheellock's outer parts being released.

The following is a list of the main parts and accessories in the wheellock mechanism that are essential to fire and reload it (parts listed here are the parts chiefly in the lock plate).


The wheelEdit

Main article: wheel (wheellock mechanism)

The wheel in the wheellock mechanism, is the centerpoint of the wheellock, which was struck by the hammer containing flint while it was spinning (after being wound up), which made sparks that were led into the flash pan.

The hammerEdit

Main article: hammer

Wheellockclose

The wheellock's hammer (right).

The hammer in the wheellock mechanism, is what held the pyrite which was struck against the wheel. Before the wheellock was fired, the hammer had to be prepared, by (if necessary) replacing the flint (or some other material); then the hammer containing the (new or old) flint was pushed down against the priming pan, where it would be released on the wheel after the trigger was pulled.

The priming panEdit

Main article: flash pan

The flash pan is what held the powder which was what ignited the main powder in the barrel, after it was exposed to sparks; the sparks were made by the hammer containing flint striking the spinning wheel.

The wheel keyEdit

Wheellock3

A sketch-style diagram showing the wheel key (right).

Main article: key (wheellock mechanism)

The key is what was used to wind the wheel up before firing, they would have to be pressed onto the wheel (where a small screw-like piece was which the key "hooked" to) and wound.



See alsoEdit

External linksEdit

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.