7.62mm redirects here, for other uses see 7.62mm (disambiguation)
7.62x51 Nato Portuguese

Some FMJ 7.62's

The 7.62x51mm NATO (7.62 NATO), is one of the standard military small arms round for the NATO countries (North Atlantic Treaty Organization).


After World War I the U.S. Army was looking for a new military round for light semi- and fully-automatic weapons. The project was the T65 rifle. In 1932, the .276 Pedersen was rejected in favor of the already established .30 caliber cartridges.

In September 1952, the .308 Winchester made its commercial debut. On December 15, 1953, NATO adopted T65E3 Ordinance test round. The T65E3 Ordnance test round was then standardized by CIP and renamed the 7.62x51mm NATO round.

During the same time period of NATO adoption, the British and Canadians chambered the FN FAL in 7.62 and the West Germans chambered the H&K G3 as well as modifying their CETME Spanish rifle in 7.62. The Americans followed suit in 1957, and adopted the 7.62 NATO M14.

Design detailsEdit

The 7.62x51mm NATO is very similar to the .308 Winchester cartridge; they are nearly completely interchangeable and share the same dimensions (7.62x51mm).

The 7.62x51mm NATO is rimless. It uses a large rifle primer, and a .308 caliber (7.82mm) bullet. The bullet is 51mm long, and the cartridge has an overall length (OAL) of 2.75 inches.

It is best fired from a barrel with a 1:12 rifling twist, and fires with a muzzle velocity between 2600 and 2800 feet per second, dependent on powder load, bullet weight, and barrel length. Bullet weights range from around 150 grains to 190 grains. However, the 7.62 NATO can use any projectile the .308 Winchester uses; pressure will be slightly lower.

The 7.62 NATO fires at a maximum pressure of 60,200 PSI (50,450 CUP). This is slightly less than the pressure of the .308 Winchester.


Ad blocker interference detected!

Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.